| Nothing radical here (yet). Just applying the conversion kit. A few places needed to be patch up, cut out. |
| I think I'm gonna make a plastic frame to use in that upper vent with a mesh plate. |
| It doesn't show in the photo, but I made some very sloppy drillings in the lower leg area. ^^; I added thin plastic sheet on the side of the knee to give the impression of it being a separate piece of armor. The groin is shortened and slapped with a 1mm sheet. It still needs a vernier underneath. |
| Added some rivets to match the line art and scribed a line around the wrist. Verniers are to be added in the shoulder where I carved away the old one. |
|
Additional details are added as followed:
|
| Old vernier is replaced with one of Wave's using pla plate as a base. The bar comes from (someone else's) MG Gundam. |
| Look familiar? Yes I rip off the design of Raiden from Gasaraki. I felt no shame 'borrowing' design elements from one mech and apply it on the same designer's another mech. :-) |
|
Some final additions are added to it. These includes
Now it's all done! Ready to be painted. |
| I also made ducts from plastic plate and attached mesh on the back of them. It's hardly visible when put together though. |
Send comments to virapat@mozart.inet.co.th
  |
|
